Jump to content

Logo

Today's Active Posts

Photo

prototype for front pocket EDC organizer


1 reply to this topic

#1 Murray Oliver

Murray Oliver

    Advanced Member

  • Members
  • PipPipPip
  • 453 posts
  • LocationToronto

Posted 02 July 2018 - 09:16 AM

Hello again from an errant past member...

 

So I have been testing thing a few months ago and have been adjusting the angle and width etc. and am happy with it now. Next step is to rebuild with the light in the middle so the whole piece will lay flatter at the edges and add a form of capture/pocket for the removable receipt holder. Final version will not be from scraps and will have a finish on it of some sort though the natural worn look that occurs is coo....so maybe just a light oil or wax on the final.

 

Any thoughts? Suggestions?

Attached Files


What nature requires is obtainable, and easily within reach. It is for the superfluous we sweat.

Lucius Annaeus Seneca

 

 

http://www.plinkercases.ca

 

 

maker@plinkercases.ca

 

 

 

 

 

 


#2 Mike Blum

Mike Blum

    Advanced Member

  • Members
  • PipPipPip
  • 67 posts

Posted 14 September 2018 - 12:16 PM

Perhaps  thin...really thin... strips of rubber on the 'leg side' of the organizer to keep it located where you put it. I would suggest using  two bicycle tire inner tube strips sewn horizontally across.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users